齒輪泵是導軌升降機傳動的首要設備，是導軌升降機重要的組成部分，如果導軌升降機出現無力的情況，那將會影響公司完成項目的進度，那么導軌升降機齒輪泵內漏應該如何解決呢？

1、導軌升降機內漏表現為工作時噪聲大、發動機轉速越高，則噪聲越大，在濾油器中可見到大量銅屑。應拆檢齒輪泵，檢測齒輪的端面間隙、齒輪的嚙合間隙、齒輪的徑向間隙，以及檢查密封件是否良好的等。如有超差或損壞，應修復或更換。
Leakage performance  lifts for big noise at work, the higher the engine speed, the greater the noise, the filter can be seen in a large number of copper scrap. Should be overhauled gear pumps, end gap detection gear backlash gears, gear radial clearance, and check the seal is good and so on. If ultra-poor or damaged, should be repaired or replaced.

2、檢查導軌升降機齒輪泵的散熱條件能否杰出，泵中齒輪、軸承等能否損壞，零件能否松動。如果油液蛻變或雜質增多，使泵的軸承研磨、燒蝕而發熱，這種狀況，除應將泵拆開清潔外，有必要替換新油。
Check the  gear pump lift outstanding thermal conditions can, pump gears, bearings, etc. can damage parts can come loose. If the fluid transformation or impurities increased, so that the pump bearing grinding, erosion and heat, this situation, in addition to the pump should be disassembled to clean the outside, it is necessary to replace the new oil.